|Product Name||Roller heat press machine|
|Brand & Model||Jiangchuan ,JC-26B|
|Voltage||220/380/420/480 3 Phase is available|
|Time & Temp range||0-999s,0-399℃|
|Warranty||1 year,oversea service available|
1.12monthes warranty, all spare parts can change free without any being damaged by any man-made factors, it can work 3-20years.
2.Operate Training, and daily maintenance would be offered if required.
3.Jiangchuan Brand, China Famous brand.
Stop working breakdown handing:
1.There is nick on the doctor blade or doctor blade became blunt, it will cause barriness or roller dirty and rough,
you should stop the machine working to rasp it.
2.If there are too much fiber nap between doctor blade and roller, stop the machine working, use a welt cloth
and knot in a head on one side, loosen the heavy hummer which hung on the doctor blade, hold on the another
side of welt cloth, swept from the knife edge, it is much easy clean the knife edge.
3.If the roller has defect, stop the machine working, tear down the roller, send it to the carving workshop to repair.
4.The inner hole will enlarge after the roller working for a long time, cause roller axis and roller loosen and can not
straight the pattern, at this time, you should stop the machine working, tear down the roller, pad the knife paper,
re-install & tight it.
5.When the fabric is printing, because of the steam is not good or tension is too big, cause to decollation, and even
the fabric twine to other parts, it will cause big accident, you should stop the machine working and breakdown handing
6.The roller bearing is damaged and emit heat, make the motor load increases, do not use the cold water to watering
the bearing, you should stop the machine working, change another axis and add lubrication grease
7.If it's long time breakdown handing you should connect the leaer fabric or conductive line, close the steam valve
in time, and release all pressure of roller
8.After breakdown handing all, should start it machine in accor