|Brand Name||Jiang Chuan|
|Item Name||Heat Transfer Rotary|
|Printing/drum width||1800 mm 70.8 inch|
|Roller diameter||420 mm 16.5 inch|
|Rated output||27 KW|
|Packing size||2730 x 1390 x1600 mm|
|Feeding Method||Top feeding|
|Air Compressor Required||Required|
|Blanket Material||Nomex: High temperature resistance|
|Drum Surface||Chrome: High hardness and abrasion performance|
1) The electric control adopts latest technology that allows separation of the machine body and the blanket automatic, with a power failure protection functions.
2) It is applicable to all over or piece hot press, with a 2-3 times higher work efficiency.
3) Electronic digital terminal temperature control and motor frequency conversion digital speed regulation, with high accuracy (±1-2°C).
4) Drum surface with chrome plating, high hardness and good printing performance, wearable and stickiness-proof.
1, Check that all screws in mainframe are loose or not, tighten if loose
2, The whole machine should be set at level with enough capacity; wood frame to overhead the sliding wheel and level direction is preferred.
3, Matched load leakage circuit breaker separately on this machine with 3×6×6+1×4×4 international power wire. The crust of machine must be earthed separately.
4, Keep the equipment in level while installation. Use two section 160×160×700(length) of bed timber under inner side of two wheel. Use level instrument to check if the machine is level or not.
5, When the working table is installed, the height must be consistent with feeding blanket and level. The paper feeding (put in) shaft and cloth feeding (put in) shaft must be of the same level with heating tank.